Toyota Super White Basecoat QUART or GALLON KIT
$84.99 – $194.99
- Makes a perfect basecoat for any of our pearls.
- Jet Black Basecoat is a direct replacement for PPG DBC 9700
- Choose a reducer speed for the right painting temperature (Fast=cold, Slow=Hot)
SIZE | GALLON KIT, QUART KIT |
---|---|
REDUCER SPEED | SLOW, MEDIUM, FAST |
Only logged in customers who have purchased this product may leave a review.
Toyota SUPER WHITE BASECOAT (Cross-Reference PPG DBC9700)
Description:
Toyota Super White Basecoat is used in the DBU basecoat systems. Super White Basecoat is available in an F-style gallon and a round quart.
Can be used with:
- Fast Urethane Reducer
- Medium Urethane Reducer
- Slow Urethane Reducer
- Ex-Slow Urethane Reducer
Application:
Apply 2-3 medium wet coats or until proper hiding is achieved. Allow 5-10 minutes flash time between coats.
Excel Basecoat Series is a quick-dry, good-hiding, factory pack line of many popular colors. Various OEM colors are available. Ideal for overalls, large blend area repairs, or for ground-coat material.
For a complete and current list of colors offered, please visit
www.excelproducts.net.
Surface Preparation:
For dry sanding, a final sanding step of P500-P600 grit is recommended using a maximum 100-grit step difference or less throughout the taken sanding steps.
For wet sanding, a final sanding step of P800-P1000 grit is recommended using a maximum of 200-grit step difference or less throughout the sanding steps.
Clean the area with a good-grade wax and grease remover such as #91001 and wipe dry with a clean cloth. Wipe the area with a tack cloth to remove any dust or dirt particles.
Mixing Directions:
- 2 Parts Excel Basecoat
- 1 Part Excel Urethane Reducer
Spray Gun Set-up:
- Compliant Gravity feed: 1.3-1.5mm, 30 PSI at the spray gun air inlet
- Gravity feed HVLP: 1.3-1.5mm, 10 PSI max at air cap
- Siphon feed: 1.6-1.8mm, 40-50 PSI
Application:
Apply 2 – 4 single coats or until full coverage is achieved.
Drying Schedule:
Allow each coat to flash off for approximately 5 to 10 minutes at 70°F.
Prior to clear coat application, allow a minimum of 20 minutes flash time at 70°F and a maximum of 24 hours flash time at 70°F.
If the maximum time is exceeded, scuff the surface and apply another coat.
Cleaning of Equipment:
Clean equipment with lacquer thinner.
Table of Contents
Reviews